Colin Archer bermudan cutter ( SOLD )
Planked in 1.5″ larch fastened with galvanised rivets and roves similar to the working boats to large laminated oak frames with a steam bent intermediate timber.
Oak back bone with an external 3 ton iron ballast keel with large iron keel bolts
Grown oak floors on each laminated frame
Straight laid 2″ Iroko deck, caulked and payed on laminated oak deck beams. Stainless steel hanging knees and lodging knees.
9″ bulwark all round with a varnished capping rail, dipping bow and stern in the usual Colin Archer way.
Coachroof aft of the mast with varnished Iroko coamings. Coachroof deck is T&G Iroko planking sheathed externally in epoxy glass cloth.
Deep self draining cockpit with tiller steering.
Bermudan cutter rig on a keel stepped varnished pole mast with single spreaders and a varnished wooden slab reefing boom.
Stainless steel standing rigging, new in 1998, to external galvanised chain plates.
Twin lower shrouds and single cap shrouds. Single standing backstay with running backstays on tackles. Inner forestay to the stem head. Outer forestay to the end of the bowsprit carries the jib on a Topp-Reff roller furling system.
2 pairs of Barlow Tuffnel winches on the cockpit coamings for headsail sheets. Single reefing winch on the boom and pair of Lewmar halyard winches on the mast.
Sails in good condition, main staysail and jib from 2006. Downwind and storm sails older but in good condition.
Volvo Penta 22L 48hp 4cyl marine diesel installed new in 1996. Serviced annually, alternator replaced 2016.
Single lever controls to centreline fixed 3 blade bronze propeller gives max speed of 8 knots.
250 litres of diesel in 2 stainless steel fuel tanks under the quarter berths,
300 litres of water in 3 stainless steel tanks under the saloon cabin sole.
2 x 12 volt batteries new in 2016
Simple but comfortable accommodation with 4 berths plus a large pipe cot and 6’5″ headroom in the saloon.
Steps down over the engine box with a decent quarter berth either side under the deck head.
Galley to starboard extending the full length of the saloon with a varnished work top, stainless sink with manually pumped fresh and salt water taps. Optimus 2 burner paraffin cooker on gimbals. Ample stowage around the galley.
Chart area to port with instruments on the bulkhead.
Dinette seating arrangement on the port side forward of the chart area gives a saloon table and seating.
Solid fuel cast iron cabin heating stove on the port side forward.
Starboard offset door into the forward cabin with a large single berth either side under the deck.
Double folding doors going forward to the forepeak with lots of stowage space and a Lavac sea toilet on the centreline facing aft
Full specification and details available upon request
Designer: Arne Hedlund Length on deck: 32'
Builder: Sakskobing Boatyard, Denmark Beam: 11'4"
Year: 1978 Draft: 6'